Skip to content
Trademarks and datasheets are the property of their respective owners

RTD2270L Datasheet – Flat Panel Display Controller

Published Updated 1 view
Package LQFP64 Type
RTD2270L-IC

RTD2270L overview

The RTD2270L is a Flat Panel Display Controller made by Realtek, supplied in an LQFP64 Type package. The absolute maximum ratings table on this page lists the 9 limits from the manufacturer's datasheet that must not be exceeded. This page brings together the RTD2270L pinout and maximum ratings, with the full datasheet PDF to preview below or download.

A flat panel display controller (FPDC) is an electronic device that serves as the interface between a computer or other image source and a flat panel display (FPD). Its primary function is to receive digital image data from the source and process it to generate the necessary signals for displaying the images on the flat panel screen.

The FPDC takes the digital image data, typically in the form of pixel values, and performs various operations such as color space conversion, scaling, image enhancement, and video processing. It also handles tasks such as refresh rate control, synchronization, and driving the display panel.

Datasheet

rtd2270l-datasheet-1.pdf
Format PDFSize 331 KBLanguage EN
Third-party / unverified source

RTD2270L features

  • General
  • Embedded DDC with DDC1/2B/CI
  • Embedded one MCU with SPI flash controller.
  • Require only one crystal to generate all timing.
  • Programmable internal low-voltage-reset (LVR)
  • High resolution 6 channels PWM output, and wide range selectable PWM frequency.
  • Support input format up to FHD
  • Embedded BJT control circuit for 1.2V regulator replacement
  • Analog RGB Input Interface
  • One Analog input supported
  • Integrated 8-bit triple-channel 210MHz ADC/PLL(option)
  • Embedded programmable Schmitt trigger of HSYNC
  • Support Sync-On-Green (SOG) and various kinds of composite sync modes
  • On-chip high-performance hybrid PLLs
  • High resolution true 64 phase ADC PLL
  • Embedded MCU
  • Industrial standard 8051 core with external serial flash
  • Low speed ADC for various application
  • I2C Master or Slave hardware supported
  • Auto Detection /Auto Calibration
  • Input format detection
  • Compatibility with standard VESA mode and support user-defined mode
  • Smart engine for Phase/Image position/Color calibration
  • Scaling
  • Fully programmable zoom ratios
  • Independent horizontal/vertical scaling
  • Advanced zoom algorithm provides high image quality
  • Sharpness/Smooth filter enhancement
  • Support non-linear scaling from 4:3 to 16:9 or 16:9 to 4:3
  • Color Processor
  • True 10 bits color processing engine
  • sRGB compliance
  • Advanced dithering logic for 18-bit panel color depth enhancement
  • Brightness and contrast control
  • Programmable 10-bit gamma support
  • Peaking/Coring function for video sharpness
  • Vivid ColorTM Independent color management (ICM) Dynamic contrast control (DCC)
  • Independent color management (ICM)
  • Dynamic contrast control (DCC)
  • Output Interface Fully programmable display timing generator Flexible data pair swapping for easier system design. Single or Dual display interface supported up to 186MHz, FHD resolution LVDS output interface Support 8 bits LVDS output Spread-Spectrum DPLL to reduce EMI Fixed Last Line output for perfect panel capability

RTD2270L pinout

RTD2270L pinout diagram
PinNameDescription
1XINCrystal input
2XOUTCrystal output
3AGND
4REXT/GPIO
5ADC_GNDADC Power
6ADC_VDD33-
7BIN1-VGA INPUT signal
8BIN1+
9GIN1-
10GIN1+
11SOG0
12RIN1-
13RIN1+
14ADC_GND
15ADC_REFADC_Reference Power
16HSYNC
17VSYNC
18DDC_SDA/GPIO/TXDDC SDA/MCU GPIO/TX
19DDC_SCL/GPIO/RXDDC SCL/MCU GPIO/ RX
20GPIO/PWM0MCU GPIO/ PWM output
21SPI_SDO/ SCSBSPI flash serial data output/ Host Interface_SCSB
22SPI_CESPI flash chip enable Note: POL pin, 1:internal MCU, 0:ext. MCU
23SPI_SCL/ SDIOSPI flash clk/ Host Interface_SDIO

Absolute maximum ratings

ParameterSymbolValueUnit
Voltage on Input (5V tolerant)VINMin -1 / Max 5V
Supply VoltagePVCCMin 3.0 / Typ 3.3 / Max 3.6V
Supply VoltageVCCKMin 1.08 / Typ 1.2 / Max 1.32V
Electrostatic DischargeVESDTyp ±2.5kV
Latch-UpILAMax ±100mA
Ambient Operating TemperatureTAMin 0 / Max 70ºC
Storage temperature (plastic)TSTGMin -55 / Max 125ºC
Thermal Resistance (Junction to Air)θJAMax TBDºC/W
Junction Acceptable TemperatureTjMax 125ºC

RTD2270L applications

  • LCD and LED TV Displays
  • Digital Television (DTV) Systems
  • High-Definition Multimedia Interface (HDMI) Integration
  • Smart TV Platforms
  • Multimedia Entertainment

RTD2270L datasheet PDF preview

PDF · 331 KB

Comments 0

Leave a comment