Skip to content
Trademarks and datasheets are the property of their respective owners

24C64 Datasheet – 64K-Bit Serial EEPROM IC

64K-Bit Standard 2-Wire Bus Interface Serial EEPROM

Published Updated 6 views
Package DIP, SO, TSSOP 8 Pin Type
24C64-IC

24C64 overview

The 24C64 is a 64K-Bit Standard 2-Wire Bus Interface Serial EEPROM made by Fairchild Semiconductor, supplied in these packages: DIP, SO, TSSOP 8 Pin Type. The absolute maximum ratings table on this page lists the 4 limits from the manufacturer's datasheet that must not be exceeded. This page brings together the 24C64 pinout and maximum ratings, with the full datasheet PDF to preview below or download.

FM24C64 is a 64Kbit CMOS non-volatile serial EEPROM organized as 8K x 8 bit memory. This device confirms to Extended IIC 2-wire protocol that allows accessing of memory in excess of 16Kbit on an IIC bus. This serial communication protocol uses a Clock signal (SCL) and a Data signal (SDA) to synchronously clock data between a master (e.g. a microcontroller) and a slave (EEPROM). FM24C64 is designed to minimize pin count and simplify PC board layout requirements.

FM24C64 offers hardware write protection where by the entire memory array can be write protected by connecting WP pin to VCC. This section of memory then becomes unalterable until the WP pin is switched to VSS.

“LZ” and “L” versions of FM24C64 offer very low standby current making them suitable for low power applications. This device is offered in SO, TSSOP and DIP packages. Fairchild EEPROMs are designed and tested for applications requiring high endurance, high reliability and low power consumption.

Datasheet

24c64-datasheet.pdf
Format PDFSize 98 KBLanguage ENRevision Rev. C
Third-party / unverified source

24C64 features

  • Extended operating voltage: 2.5V to 5.5V
  • Up to 400 KHz clock frequency at 2.5V to 5.5V
  • Low power consumption
  • 0.5mA active current typical
  • 10mA standby current typical
  • 1mA standby current typical (L version)
  • 0.1mA standby current typical (LZ version)
  • Schmitt trigger inputs
  • 32 byte page write mode
  • Self timed write cycle (6ms typical)
  • Hardware Write Protection for the entire array
  • Endurance: up to 100K data changes
  • Data Retention: Greater than 40 years
  • Packages: 8-Pin DIP, 8-Pin SO and 8-Pin TSSOP
  • Temperature range
  • Commercial: 0°C to +70°C
  • Industrial (E): -40°C to +85°C
  • Automotive (V): -40°C to +125°C

24C64 pinout

24C64 pinout diagram
NameDescription
VSSGround
SDASerial Data I/O
SCLSerial Clock Input
WPWrite Protect
VCCPower Supply
A0, A1, A2Device Address Inputs

Absolute maximum ratings

ParameterValue
Ambient Storage Temperature–65°C to +150°C
All Input or Output Voltages with Respect to Ground6.5V to –0.3V
Lead Temperature (Soldering, 10 seconds)+300°C
ESD Rating2000V min

24C64 applications

  • I2C EEPROM Data Storage
  • Microcontroller Communication
  • Embedded Systems Memory
  • Consumer Electronics
  • Industrial Automation

24C64 datasheet PDF preview

PDF · 98 KB

Comments 0

Leave a comment