Skip to content

ATtiny85V-10SU Datasheet 8-Bit 8KB AVR

AVR Microcontroller

Published Updated 2,015 views Report an error
Package 8 Pin SMD Series ATtiny (AVR)
ATtiny85V-10SU Datasheet 8-Bit 8KB AVR

ATTINY85V-10SU overview

A low-power, 8-bit CMOS microcontroller built on the AVR-enhanced RISC architecture is called the ATtiny25/45/85. The ATTINY85V-10SU achieves throughputs close to 1 MIPS per MHz by carrying out strong instructions in a single clock cycle, enabling the system designer to balance power consumption and processing performance. 32 general-purpose working registers and a robust instruction set are combined in the AVR core. Due to the direct connection of all 32 registers to the Arithmetic Logic Unit (ALU), two separate registers can be accessed in a single instruction that is executed in a single clock cycle. In comparison to traditional CISC microcontrollers, the resulting design is more code efficient and achieves throughputs that are up to ten times quicker.

The following capabilities are provided by the ATtiny25/45/85 microcontroller which belongs to Embedded IC: A 4-channel, 10-bit ADC, programmable Watchdog Timer with internal Oscillator, one 8-bit Timer/Counter with compare modes, one 8-bit high-speed Timer/Counter, 128/256/512 bytes of EEPROM, 128/256/256 bytes of SRAM, 6 general purpose I/O lines, 32 general purpose working registers, Universal Serial Interface, Internal, and External Interrupts, and three software selectable power saving modes are all included. The CPU is put into idle mode, while the SRAM, Timer/Counter, ADC, Analog Comparator, and Interrupt system are still operational. All chip operations are disabled in power-down mode until the next interrupt or hardware reset, which stores the register values. To reduce switching noise during ADC conversions, the CPU and all other I/O modules are stopped in the ADC Noise Reduction mode.

Part NumberATtiny85V-10SU
FunctionAVR Microcontroller
Package8 Pin SMD
ManufacturerAtmel
DatasheetDownload PDF AM5890S pdf
ATtiny85V-10SU AVR IC

Key specifications

Integrated Circuits (ICs) Embedded Microcontrollers
Category
Microchip Technology
Mfr
AVR® ATtiny, Functional Safety (FuSa)
Series
Tube
Package
Active
Product Status
Verified
DigiKey Programmable
AVR
Core Processor
8-Bit
Core Size

Datasheet

attiny85-10su-avr-datasheet.pdf
Format PDFSize 6.5 MBLanguage EN
Third-party / unverified source

ATTINY85V-10SU features

  • High Performance, Low Power AVR® 8-Bit Microcontroller
  • Advanced RISC Architecture
  • 120 Powerful Instructions – Most Single Clock Cycle Execution
  • 32 x 8 General Purpose Working Registers
  • Fully Static Operation
  • Non-volatile Program and Data Memories 2/4/8K Bytes of In-System Programmable Program Memory Flash
  • 2/4/8K Bytes of In-System Programmable Program Memory Flash
  • Endurance: 10,000 Write/Erase Cycles 128/256/512 Bytes In-System Programmable EEPROM
  • 128/256/512 Bytes In-System Programmable EEPROM
  • Endurance: 100,000 Write/Erase Cycles
  • 128/256/512 Bytes Internal SRAM
  • Programming Lock for Self-Programming Flash Program and EEPROM Data Security
  • Peripheral Features
  • 8-bit Timer/Counter with Prescaler and Two PWM Channels
  • 8-bit High-Speed Timer/Counter with Separate Prescaler
  • 2 High-Frequency PWM Outputs with Separate Output Compare Registers
  • Programmable Dead Time Generator USI – Universal Serial Interface with Start Condition Detector 10-bit ADC
  • USI – Universal Serial Interface with Start Condition Detector
  • 10-bit ADC
  • 4 Single Ended Channels
  • 2 Differential ADC Channel Pairs with Programmable Gain (1x, 20x)
  • Temperature Measurement
  • Programmable Watchdog Timer with Separate On-chip Oscillator
  • On-chip Analog Comparator
  • Special Microcontroller Features
  • debugWIRE On-chip Debug System
  • In-System Programmable via SPI Port
  • External and Internal Interrupt Sources
  • Low Power Idle, ADC Noise Reduction, and Power-down Modes
  • Enhanced Power-on Reset Circuit
  • Programmable Brown-out Detection Circuit
  • Internal Calibrated Oscillator
  • I/O and Packages
  • Six Programmable I/O Lines
  • 8-pin PDIP, 8-pin SOIC, 20-pad QFN/MLF, and 8-pin TSSOP (only ATtiny45/V)
  • Operating Voltage 1.8 - 5.5V for ATtiny25V/45V/85V 2.7 - 5.5V for ATtiny25/45/85
  • 1.8 - 5.5V for ATtiny25V/45V/85V
  • 2.7 - 5.5V for ATtiny25/45/85
  • Speed Grade ATtiny25V/45V/85V: 0 – 4 MHz @ 1.8 - 5.5V, 0 - 10 MHz @ 2.7 - 5.5V ATtiny25/45/85: 0 – 10 MHz @ 2.7 - 5.5V, 0 - 20 MHz @ 4.5 - 5.5V
  • ATtiny25V/45V/85V: 0 – 4 MHz @ 1.8 - 5.5V, 0 - 10 MHz @ 2.7 - 5.5V

ATTINY85V-10SU pinout

ATTINY85V-10SU pinout diagram

ATTINY85V-10SU specifications

Integrated Circuits (ICs) Embedded Microcontrollers Category
Microchip Technology Mfr
AVR® ATtiny, Functional Safety (FuSa) Series
Tube Package
Active Product Status
Verified Digi Key Programmable
AVR Core Processor
8-Bit Core Size
10MHz Speed
USI Connectivity
Brown-out Detect/Reset, POR, PWM, WDT Peripherals
6 Number of I/O
8KB (4K x 16) Program Memory Size
FLASH Program Memory Type
512 x 8 EEPROM Size
512 x 8 RAM Size
1.8V ~ 5.5V Voltage - Supply (Vcc/Vdd)
A/D 4x10b Data Converters
Internal Oscillator Type
-40°C ~ 85°C (TA) Operating Temperature
8-SOIC (0.209", 5.30mm Width) Mounting Type
8-SOIC Supplier Device Package
ATTINY85 Base Product Number

More about ATTINY85V-10SU

ATtiny85-10SU Block Diagram

ATtiny85-10SU Features

  • Advanced RISC Architecture
  • Non-volatile Program and Data Memories
  • Endurance: 10,000 Write/Erase Cycles
  • Endurance: 100,000 Write/Erase Cycles
  • Peripheral Features
  • Programmable Dead Time Generator
  • Temperature Measurement
  • Special Microcontroller Features
  • I/O and Packages
  • Operating Voltage
  • Speed Grade

Tags

ATTINY85V-10SU datasheet PDF preview

PDF · 6.5 MB

Comments 0

Leave a comment