Skip to content
Trademarks and datasheets are the property of their respective owners

CH376S USB Flash Disk Arduino Disk Read-write Module

Published Updated 4 views

CH376S overview

This is CH375B USB Disk Read-write Module USB Flash Disk For Arduino. USB interface in the current electronic products accounted for a very large share of the microcontroller with USB interface communication direction of one of the most popular microcomputer application master chip modules using the CH375, CH375 is a USB bus interface chip to support USB-The hOST and USB-DEVICE/SLAVE equipment the way. Locally, CH375 with the 8-bit data bus and read, write, chip select control lines, and interrupt output can be easily attached to the system bus of the microcontroller/DSP/MCU/MPU controller. USB host mode, CH375 also provides serial communication via serial input, serial output, and interrupt output monolithic/DSP/MCU/MPU connected.

CH375 USB device mode is fully compatible with CH372, CH375 contains all the features of the CH372. Common CH375 USB host mode supports a USB full-speed device, the external microcontroller can through the CH375 in accordance with the USB protocol and USB device communication. CH375 firmware also built a dedicated protocol processing Mass-Storage mass storage devices, the external microcontroller can be directly used as the basic unit of reading and writing in sectors of USB storage devices (including USB hard disk/USB flash drive/U disk).

Key specifications

Size
48 x 28 (LxW) mm
Color
Blue
Crystal
12 MHZ

Datasheet

ch376s-module.pdf
Format PDFSize 212 KBLanguage EN
Third-party / unverified source

CH376S features

  • CH375B with the 8-bit data bus and read, write, chip select control lines and interrupt output can be easily attached to the system bus of the microcontroller/DSP/MCU/MPU controller.
  • USB host mode, CH375B provides serial communication via serial input, serial output, and interrupt output monolithic/DSP/MCU/MPU connected.
  • 2×8 connector, easy with the MCU mount.
  • Jumper selectable can work in parallel or serial mode.
  • USB status indicator.
  • On board 3.3 V LDO 1117, provides 800 mA current.
  • A 5V power supply is powered by the target board.

CH376S datasheet PDF preview

PDF · 212 KB

Comments 0

Leave a comment