ESP-04 ESP8266 Low Power WiFi Module
ESP-04 overview
The ESP-04 is an ESP8266 Low Power WiFi Module made by Espressif Systems, supplied in a QFN-48 package. Main ratings: Controller ESP8266EX Serial WiFi 32-bit Tensilica L106 SoC; Working voltage 3.3V; Supported voltage 3.0 - 3.6V; Working current 71-80mA. This page brings together the ESP-04 pinout and key specifications, with the full datasheet PDF to preview below or download.
ESP-04 ESP8266 UART WiFi module is an ultra-low power consumption, WiFi passthrough module. It is highly competitive in the industry of packaging size and low power consumption technology, designed particularly for mobile IoT devices and Internet applications. The module encapsulation mode is diversiform, the onboard antenna can support board PCB, IPEX interfaces, and stamp holes with three distinct three forms. ESP-04 ESP8266 is used for a wide variety of applications such as in smart grid, smart transportation, intelligent power systems, handheld devices, industrial control, etc
ESP-04 can handle all the necessary overhead for communicating with your network. Such as TCP/IP stack and communicating with your 802.11 networks. The module also supports APSD for VoIP applications and Bluetooth co-existence interfaces, using a self-calibrated RF that allows ESP-04 to work under all operating conditions while requiring no external RF parts.
Key specifications
Datasheet
ESP-04 features
- 802.11 b/g/n protocol
- Wi-Fi 2.4 GHz, support WPA/WPA2
- Super small module size
- Integrated 10-bit ADC
- Integrated TCP/IP protocol stack (ipv4 only at the moment)
- Integrated TR switch, balun, LNA, power amplifier, and matching network Integrated PLL, regulators, and power management units
- +20dBm output power in 802.11b mode
- Supports antenna diversity
- Integrated low-power 32-bit MCU
- SDIO 2.0, SPI, UART, I2C
- STBC, 1x1 MIMO, 2x1 MIMO
- A-MPDU & A-MSDU aggregation & 0.4μs guard interval
- Wake up and transmit packets in < 2ms
ESP-04 pinout
| Pin | Name | Description |
|---|---|---|
| 1 | VCC | Chip Supply Voltage |
| 2 | GPIO 14 | general purpose contact 14, data input/output. Reassignable to other functions |
| 3 | GPIO 12 | general purpose contact 12, data input/output. Reassignable to other functions |
| 4 | GPIO 13 | general purpose contact 13, data input/output. Reassignable to other functions |
| 5 | GPIO 15 | general purpose contact 15, data input/output. Reassignable to other functions |
| 6 | GPIO 2 | general purpose contact 2, data input/output. Reassignable to other functions |
| 7 | GPIO 0 | general purpose contact 0, data input/output. Reassignable to other functions |
| 8 | GND | Ground Pin |
| 9 | N/C | Not Connected |
| 10 | TX | Module transmission pin |
| 11 | RX | Module Receiving Pin |
| 12 | GPIO 16 | general purpose contact 16, data input/output. Connecting to the EXT_RSTB pin wakes up the module from deep sleep mode |
| 13 | CH_PD | contact for enabling the module in operating mode. Active when the signal is high |
| 14 | ANT | WiFi antenna pin |
ESP-04 specifications
| Controller | ESP8266EX Serial WiFi 32-bit Tensilica L106 SoC |
|---|---|
| Working voltage | 3.3V |
| Supported voltage | 3.0 - 3.6V |
| Working current | 71-80mA |
| Maximum current | 300mA |
| Shallow sleep current | 2mA |
| Deep sleep current | 0.02mA |
| Flash memory | 8 MB / 1 MB |
| WiFi Protocols | 802.11b/g/n |
| Frequency range | 2.4GHz-2.5GHz (2412M-2484M) |
| WiFi Modes | Client, Soft AP, Client+Soft AP (station, softAP, station+softAP) |
| Security | WPA-PSK, WPA2-PSK |
| Encryption | WEP, TKIP, AES |
| Network protocols | IPv4, TCP/UDP/HTTP/FTP |
| General Purpose Pins (In/Out, GPIO) | 9 |
| Maximum current per general purpose contact | 12mA, recommended 6mA |
| Output power in 802.11b mode | +20dBm |
| Interfaces | UART, GPIO, HSPI, I2C, I2S |
| Baud rate | 300-4608000 baud, default 115200 baud |
| Built-in blocks | network matching, phase-locked loop, power management, regulation blocks |
| Pin spacing | 2.00 mm |
| Working temperature | -40°...+125° |
| Dimensions | 14.7 x 12.1 x 3mm |
ESP-04 applications
- IoT Devices
- Home Automation equipment
- HVAC process automation
Comments 0
Leave a comment