Espressif ESP32 WROOM 32D Development Board features
CVSDandSBC
ESP32-D0WD-V3embedded,Xtensa dual-core
SDcard, UART, SPI, SDIO, I2C, LED PWM,
448 KB ROMfor booting and core functions
520 KB SRAMfor data and instructions
16 KB SRAMin RTC
802.11b/g/n
40 MHz crystal oscillator
Bit rate: 802.11n up to 150 Mbps
8 MB SPI flash
A-MPDUandA-MSDUaggregation
0.4 µs guard interval support Antenna Options
On-board dual PCB antennas
Center frequency range of operating channel
Operating voltage/Power supply: 3.0 ~ 3.6 V
Espressif ESP32 WROOM 32D Development Board applications
Generic Low-power IoT Sensor Hub • Smart Building
Generic Low-power IoT Data Loggers • Industrial Automation
Cameras for Video Streaming • Smart Agriculture
Over-the-top (OTT) Devices • Audio Applications
Speech Recognition • Health Care Applications
Image Recognition • Wi-Fi-enabled Toys
Mesh Network • Wearable Electronics
Home Automation • Retail & Catering Applications
More about Espressif ESP32 WROOM 32D Development Board
Features of ESP32 WROOM Development Board
ESP32-DevKitC is an AWS-qualified development board. In addition to Espressif’s own ESP-IDF SDK, you can use Amazon FreeRTOS on ESP32-DevKitC.
Built around ESP32-WROOM-32, this minimum system development board achieves optimal performance with its rich peripheral set, Wi-Fi, and Bluetooth connectivity offered by our flagship SoC, ESP32.
ESP32-DevKitC has your basic system requirements already covered.
ESP32-DevKitC contains the entire basic-support circuitry for ESP32-WROOM-32, including a USB-UART bridge, reset- and boot-mode buttons, an LDO regulator, and a micro-USB connector.
The ESP32-DevKitC pinout is optimized to enable prototyping on a breadboard.
Espressif ESP32 WROOM 32D Development Board datasheet PDF preview
Comments 0
Leave a comment