Skip to content

JMS539 Datasheet – USB to SATA II 3.0G Bridge Controller

SuperSpeed USB to SATA II 3.0G Bridge Controller

Published Updated 30 views Report an error
Package 64-pin LQFP, 64-pin QFN

JMS539 overview

The JMS539 is a bridge controller, which translates the communication protocol between SATA II 3.0G and SuperSpeed USB commands. The integrated 60MIPS 8051, SATA II, Hi-Speed USB and SuperSpeed USB technology enable users to perform SuperSpeed USB to SATA II 3.0G, applications in a signal chip.
In this chip, the Hi-Speed/SuperSpeed USB controller supports the USB Mass Storage Class Bulk-Only Transport Specification.

Part NumberJMS539
FunctionSuperSpeed USB to SATA II 3.0G Bridge Controller
Package64-pin LQFP, 64-pin QFN
ManufacturerJMicron
DatasheetDownload PDF AM5890S pdf

Datasheet

jms539-datasheet.pdf
Format PDFSize 125 KBLanguage EN
Third-party / unverified source

JMS539 features

  • Complies with Gen2i/Gen2m of Serial ATA II Electrical Specification 2.6
  • Supports SATA II Asynchronous Signal Recovery (Hot Plug) feature
  • Complies with USB 3.0 Specification, USB Mass Storage Class, Bulk-Only Transport Specification
  • Supports USB Super-Speed/High-Speed/Full-Speed Operation
  • Supports USB HID operation
  • Supports USB2.0/USB3.0 power saving mode
  • Supports AES-128/256 for data encryption over USB2.0/USB3.0
  • Supports external SPI NVRAM for Vendor VID/PID of USB2.0/USB3.0 device controller
  • Supports ATA/ATAPI PACKET command set
  • 12 GPIOs for customization
  • Provides hardware control PWM
  • Provides software utilities for downloading the upgraded firmware code under USB2.0/USB3.0
  • Design for Win2000, WinXP, WinVista, Win7, MAC 9.2 or later version.
  • Supports 25MHz external crystal
  • Embedded 3.3V to 1.2V voltage regulator
  • 0.13um CMOS technology
  • 64 LQFP package (10x10) and 64 QFN package (9x9)

JMS539 applications

  • Enclosure system
  • Optical storage
  • Storage system

JMS539 datasheet PDF preview

PDF · 125 KB

Comments 0

Leave a comment