MSP430G2553 Datasheet PDF – Mixed Signal Microcontroller
MSP430G2553 overview
The MSP430G2553 is a Mixed Signal Microcontroller made by Texas Instruments, supplied in these packages: TSSOP 20, TSSOP 28, VQFN 32 Pin Type. The absolute maximum ratings table on this page lists the 5 limits from the manufacturer's datasheet that must not be exceeded. This page brings together the MSP430G2553 pinout and maximum ratings, with the full datasheet PDF to preview below or download.
The Texas Instruments MSP430 family of ultra-low-power microcontrollers consists of several devices featuring different sets of peripherals targeted for various applications. The architecture, combined with five low-power modes, is optimized to achieve extended battery life in portable measurement applications. The device features a powerful 16-bit RISC CPU, 16-bit registers, and constant generators that contribute to maximum code efficiency. The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less than 1 µs.
The MSP430G2x13 and MSP430G2x53 series are ultra-low-power mixed signal microcontrollers with built-in 16- bit timers, up to 24 I/O capacitive-touch enabled pins, a versatile analog comparator, and built-in communication capability using the universal serial communication interface. In addition the MSP430G2x53 family members have a 10-bit analog-to-digital (A/D) converter.
Typical applications include low-cost sensor systems that capture analog signals, convert them to digital values, and then process the data for display or for transmission to a host system.
Datasheet
MSP430G2553 features
- Low Supply-Voltage Range: 1.8 V to 3.6 V
- Ultra-Low Power Consumption
- Active Mode: 230 µA at 1 MHz, 2.2 V
- Standby Mode: 0.5 µA
- Off Mode (RAM Retention): 0.1 µA
- Five Power-Saving Modes
- Ultra-Fast Wake-Up From Standby Mode in Less Than 1 µs
- 16-Bit RISC Architecture, 62.5-ns Instruction Cycle Time
- Basic Clock Module Configurations
- Internal Frequencies up to 16 MHz With Four Calibrated Frequency Internal Very-Low-Power Low-Frequency (LF) Oscillator
- Internal Very-Low-Power Low-Frequency (LF) Oscillator
- 32-kHz Crystal
- External Digital Clock source
- Two 16-Bit Timer_A With Three
- Up to 24 Capacitive-Touch Enabled I/O Pins
- Universal Serial Communication Interface
- Enhanced UART Supporting Auto Baudrate Detection (LIN)
- IrDA Encoder and Decoder
- Synchronous SPI
- I2C™
- On-Chip Comparator for Analog Signal Compare Function or Slope Analog-to-Digital (A/D) Conversion
- 10-Bit 200-ksps Analog-to-Digital (A/D) Converter With Internal Reference, Sample- and-Hold, and Autoscan
- Brownout Detector
- Serial Onboard Programming,
- No External Programming Voltage Needed, Programmable Code Protection by Security
MSP430G2553 pinout
Absolute maximum ratings
| Parameter | Value |
|---|---|
| Voltage applied at VCC to VSS | –0.3 V to 4.1 V |
| Voltage applied to any pin (2) | –0.3 V to VCC + 0.3 V |
| Diode current at any device pin | ±2 mA |
| Storage temperature range, Tstg (3) | Unprogrammed device / –55°C to 150°C |
| Programmed device | –55°C to 150°C |
MSP430G2553 applications
- Microcontroller Projects
- Embedded Systems
- Wearable Devices
- Sensor Interfaces
- Home Automation

Comments 0
Leave a comment