The VIPER22A is an LOW POWER OFF LINE SMPS PRIMARY SWITCHER made by STMicroelectronics, supplied in a DIP or SO 8 Pin type package. The absolute maximum ratings table on this page lists the 9 limits from the manufacturer's datasheet that must not be exceeded. This page brings together the VIPER22A pinout and maximum ratings, with the full datasheet PDF to preview below or download.
The VIPer22A combines a dedicated current mode PWM controller with a high voltage Power MOSFET on the same silicon chip. Typical applications cover off line power supplies for battery charger adapters, standby power supplies for TV or monitors, auxiliary supplies for motor control, etc. The internal control circuit offers the following benefits:
FIXED 60 KHZ SWITCHING FREQUENCY n 9V TO 38V WIDE RANGE VDD VOLTAGE
CURRENT MODE CONTROL
AUXILIARY UNDERVOLTAGE LOCKOUT WITH HYSTERESIS
HIGH VOLTAGE START UP CURRENT SOURCE
OVERTEMPERATURE, OVERCURRENT AND OVERVOLTAGE PROTECTION WITH AUTORESTART
VIPER22A pinout
Name
Description
VDD
Power supply of the control circuits. Also provides a charging current during start up thanks to a high voltage current source connected to the drain. For this purpose, an hysteresis comparator monitors the VDD voltage and provides two thresholds: VDDon: Voltage value (typically 14.5V) at which the
SOURCE
Power MOSFET source and circuit ground reference.
DRAIN
Power MOSFET drain. Also used by the internal high voltage current source during start up phase for charging the external VDD capacitor.
FB
Feedback input. The useful voltage range extends from 0V to 1V, and defines the peak drain MOSFET current. The current limitation, which corresponds to the maximum drain current, is obtained for a FB pin shorted to the SOURCE pin.
Absolute maximum ratings
Parameter
Symbol
Value
Unit
Switching Drain Source Voltage (Tj=25 ... 125°C) (See note 1)
VDS(sw)
-0.3 ... 730
V
Start Up Drain Source Voltage (Tj=25 ... 125°C) (See note 2)
VDS(st)
-0.3 ... 400
V
Continuous Drain Current
ID
Internally limited
A
Supply Voltage
VDD
0 ... 50
V
Feedback Current
IFB
3
mA
Electrostatic Discharge: Machine Model (R=0W; C=200pF) Charged Device Model
Comments 0
Leave a comment