Skip to content

VNH2SP30 Motor Driver Monster Moto Shield

Published Updated 38 views Report an error

VNH2SP30 overview

Monster Moto Shield VNH2SP30 Motor Driver 14A is essentially a ramped-up version of our Ardumoto motor driver shield. For this Monster Moto Shield, we’ve replaced the L298 H-bridge with a pair of VNH2SP30 full-bridge motor drivers. We’ve also beefed up the support circuitry so this board is capable of driving a pair of high-current motors! The VIN and motor out are pitched for our 5mm screw terminals (not included), making it easy to connect larger gauge wires.

Key specifications

Peak Current capacity
30 A
The maximum Voltage is
16V

Datasheet

vnh2sp30.pdf
Format PDFSize 654 KBLanguage ENRevision Rev. 9
Third-party / unverified source

VNH2SP30 features

  • Capable to drive two DC motors or one stepper motor
  • Continuous current capacity 14 A
  • Thermal Shutdown pin configured to provide output to Arduino Analog Pin
  • The Maximum PWM frequency is 30 kHz. For most of our Hi-Torque DC motors 12 V, 10 kHz PWM is recommended

VNH2SP30 pinout

NameDescription
VMModule Voltage
VCCModule power supply
GNDGround
A1The positive end for motor A
A2The negative end for motor A
B1The positive end for motor B
B2The negative end for motor B
PWMAThe speed control signal for motor A
INAMotor Control signal
INBMotor Control signal
CSCurrent Sensor
ENActivation pin

VNH2SP30 datasheet PDF preview

PDF · 654 KB

Comments 0

Leave a comment