Skip to content

PIC16F886 ISO SOIC28 Legs maybe bend a little bit Microcontroller

Published Updated 18 views Report an error
Package PDIP, QFN, SOIC Series PIC

PIC16F886 overview

The PIC16F886 is an ISO SOIC28 Legs maybe bend a little bit Microcontroller made by Microchip Technology, supplied in these packages: PDIP, QFN, SOIC. The full PIC16F886 datasheet PDF can be previewed below or downloaded.

With the PIC16F886-I/SO microcontroller from Microchip Technology, you can program a circuit to perform tasks that meet your desired specifications. This PIC16 Microcontroller has a minimum operating temperature of -40 °C and a maximum of 85 °C. It has a maximum clock speed of 20 MHz. Its flash program memory is 14KB. This device is based on the PIC core architecture. This device has a typical operating supply voltage of 5 V. Its minimum operating supply voltage of 4.5 V, while its maximum is 5.5 V. This is an 8-bit processor. Its ADC resolution is 10.

Datasheet

41291d.pdf
Format PDFSize 4.8 MBLanguage EN
Third-party / unverified source

PIC16F886 features

  • Only 35 instructions to learn: • 24/35 I/O pins with individual direction control:
  • Operating speed: - Interrupt-on-Change pin
  • Interrupt capability • Analog Comparator module with
  • 8-level deep hardware stack - Two analog comparators
  • Direct, Indirect and Relative Addressing modes - Programmable on-chip voltage reference
  • Precision Internal Oscillator: - Comparator inputs and outputs externally
  • A/D Converter
  • Timer0: 8-bit timer/counter with 8-bit
  • Enhanced Timer1
  • Power-Saving Sleep mode - 16-bit timer/counter with prescaler
  • Wide operating voltage range (2.0V-5.5V) - External Gate Input mode
  • Industrial and Extended Temperature range - Dedicated low-power 32 kHz oscillator
  • Power-on Reset (POR) • Timer2: 8-bit timer/counter with 8-bit period
  • Power-up Timer (PWRT) and Oscillator Start-up register, prescaler and postscaler
  • Enhanced Capture, Compare, PWM+ module

PIC16F886 datasheet PDF preview

PDF · 4.8 MB

Comments 0

Leave a comment